弯头,法兰,钢管,管件-沧州皓冠管业有限公司
Transverse ripple compensator for tie rod
Transverse ripple compensator for tie rod

Transverse ripple compensator for tie rod

The transverse ripple compensator of tie rod is used to compensate the transverse displacement of bent pipe. It...
Order immediately

The transverse ripple compensator of tie rod is used to compensate the transverse displacement of bent pipe. It can compensate the lateral and angular displacement of bending pipe.

Product description of transverse ripple compensator for tie rod

Model: dn100-dn5000, pressure level: 0.1mpa - 2.5mpa.

Connection mode: 1, flange connection 2, connection connection

Horizontal compensation amount: according to user requirements

Guide for transverse ripple compensator of tie rod

Calculation of the force exerted on the support by the transverse ripple compensator of large tie rod:

Lateral elasticity: Fy=Ky·Y bending moment: M=Fy·L

Where: ky-lateral stiffness N/mm y-lateral actual displacement (deformation amount) mm

L- distance m from the pipe frame to the center point of compensator.

Installation of transverse ripple compensator of tie rod

1. After the arrival of compensator, the following contents shall be unpacked for inspection:

Documentation: check whether the model, specification and technical parameters listed on the label and qualification certificate of compensator are consistent, and whether other necessary subsidiary technical documents are complete.

Appearance inspection: there is no obvious scratch or sharp indentation on the compensator; There should be no foreign matter inside the compensator (trough); The connecting port should be in good condition, such as flange connection sealing surface should have no penetration scar, coating without peeling, cracking, peeling, large pull rod, transport pull rod and fastener should be complete.

2. Precautions for hoisting and transportation of compensator:

Special lifting fixture or lifting lug should be used when lifting. It is forbidden to use transport rod as load bearing part. Small diameter compensator without lifting lug, because of its light weight, can be tied on the pipe with rope.

Transportation, storage process to prevent sun and rain, water immersion, harmful gas corrosion.

Transport, in storing a process, want to prevent fall, collision, do not pile up together with other article, lest bump damage bellows.

The transportation process should be bound firmly to prevent movement and rolling.